THEMA:

Ok - have now recalibrated but without any improvement. Unless there are any other thoughts I guess I have a faulty unit and will need to return it to Jeti for investigation?

Thanks for all your help

Bob

Hi,

perhaps you do a last try:

make a downgrate to 2.01 software and look ....or delete the complete SD card and put all new to SD card (also Config.sys folder etc.)


Regards

PW

-

OR you can upload your model configuration file so that we can take a look ("Model" folder)

Hi BW10

i doubt that your unit is faulty, but it's not impossible.
Try to setup a new model without copying any of your existing models.
There are just too many ways to inadvertely limit your elevator deflection.
With a new 'virgin' setup you should get proof if it is your hardware or the user

Best regards,
Meikel.

Ok - I have set up 2 new models with the same effect but I will try reloading the complete software from scratch as suggested by PW and create another model. If the problem persists I will then upload the model file for you all to look at - if you tell me how to upload it here!

Thanks again

Bob