THEMA:

Hi BW10,

push the button

Ok - have reloaded software as suggested and created a new very simple model just following the basic set up prompts and I get the same result. This is only on the elevator control i.e. in my case right stick moving top to bottom. All other controls behave normally.

Will attempt to attach the model file. Just as a matter of interest, what software do you use to look at .jsn files? Sorry to be asking such basic questions but Jeti is a different world from what I'm used to.

B

For viewing JSON ffiles on the Internet are many online JSON viewers.

Have you check the stick-movements (menu-system-view inputs)? The marker must follow the stick and move over the full square.

In your JSON file I see no strange things.

In the receiver output screen the bars must follow the stickmovements.

Hi Nicos,

Yes I have checked the stick movements as you suggest and the bars do not follow the stick movements. Given that I have reset all the software I guess this leaves me with a hardware fault?

Thanks for the help so far and grateful for any further thoughts

Best regards

B

Hi Bob,

please check your Ailevator Settings.

If you selected a Model with 2 Elevator Servos and the Ailevator is set to 50% Elevator and 50% Aileron this would explain your Transmitter behavier.

In this case set the Elevator to 100% in the Ailevator Settings and all should work fine.

Regards Heiko

This is not the case. On my transmitter the model file works okay (elevator from -100% to 100%). Maybe the stick mechanism was damaged during transport?