THEMA:

Hi all

At page 96 in the FW 3.00 manual it is explained that if you want to make a free mix control another free mix you have to enable the "Slave link" and in the mix you want to have controlled by the first mix you have to enable the "Master link"

Question:
How do I tell the first mix that I want it to control the second mix, and vice versa for the second mix? This is not explained in the manual. I have searched through the options given in the "Select input Control" window, but i do not see any free mixes appearing there.

Any clever hints out there?

Best regards
Regnar

Hallo Regnar,
That is quit simple.
1.) Make a function "A" with no Switch.
2.) Make a free mixer "Elevator" TO "A" with Master Value 30% and activate Option Slave Link +
Now if you pull the Elevator stick full the channel of function "A" shows 30%.
3.) Make a free mixer "A" to "Rudder" with Master Value 100% and activate Option Master Link +
Now if you pull the Elevator stick full the channel of function rudder shows 30% too.
That means that the result value of function "A" is now the stick position for the second mixer.
If you use Option Master Link - the stick position for the second mixer is -30%.(negativ)

If you do not activate Slave Link + in the first mixer, the result of rudder is 0% because the second mixer dont use the result of function "A"
and it use the stick position of function "A" and that it is 0% without defined stick!!

WITH GREETS
Harald

Thank you Harald

Is this explained anywhere in the manual, or should I give Jeti a hint?