THEMA:

alfasud schrieb:

@Raf - Thank you for quick answer

- When I disconnect Rsat from R18 Sat1 port, an alarm "Signal Loss" immediately appears. Regardless if I enabled "Morse code alarms" or not. In the same time I lost telemetry for Rec: Antenna and Rec: Voltage Rx. I have Unisens-E vario connected to R18 and it's telemetry remains. See pic "Signal Lost" and "Signal OK"

I just repeated this test, this time indoor. I simulated distance by placing TX behind heavy metal door at aprox. 15 m. See pic "RangeTest" Then my helper covered R18 antennas with his hand. We managed to achieve "Signal Lost" and this time Rsat was able to do some job, although rudder, on servo-tester, moved very irregularly. Under this condition, I also noticed that only digital servo for big "Fema" gear also kicked few times. Maybe I should set it's failsafe to "No signal" instead to "Hold".

Boris

Hallo Leute,
dieser Thread ist zwar schon älter aber ich bin durch einen Querverweis auf diese Seite gekommen.

Guckst Du ( www.jetiforum.de/index.php/4-jeti-sender...sat-2-binden?start=6 )

Wenn jetzt noch jemand die Ausführungen von Ralf ins les- und verstehbare Deutsch übersetzten könnte, wäre das eine tolle Sache.
Danke schon jetzt an den Übersetzer !!!